ASTM D6923 Standard Test Method for Evaluation of Engine Oils in a High Speed, Single-Cylinder Diesel Engine - Caterpillar 1R Test Procedure
4. Summary of Test Method
4.1 Prior to each test, the power section of the engine is disassembled, solvent-cleaned, measured, and rebuilt in strict accordance with the specifications. A new piston, ring assembly, and cylinder liner are measured and installed for each test. The engine crankcase is solvent-cleaned, and worn or defective parts are replaced. The test stand is equipped with feedback control systems for fuel rate, engine speed, and other engine operating conditions. Provide a suitable system for filtering, compressing, humidifying, and heating the inlet air along with a system for controlling the engine exhaust pressure. Test operation involves the control of the single-cylinder diesel test engine, using the test oil as a lubricant, at a specified speed and fuel rate input, for a total of 504 h. A defined break-in precedes each test. A prescribed warm-up is used when restarting the engine. At the end of the test, the piston deposits are rated; the piston, rings and liners are inspected, measured, and photographed; oil consumption is calculated, and the oil is analyzed to determine the test results. Critical engine operating conditions are statistically analyzed to determine if the test was precisely operated. Test acceptability parameters, for each calibration test, are also statistically analyzed to determine if the engine/test stand produce the specified results.
5. Significance and Use
5.1 This is an accelerated engine oil test, performed in a standardized, calibrated, stationary single-cylinder diesel engine that gives a measure of (1) piston and ring groove deposit forming tendency, (2) piston, ring, and liner scuffing and (3) oil consumption. The test is used in the establishment of diesel engine oil specification requirements as cited in Specification D4485 for appropriate API Performance Category C oils (API 1509). The test method can also be used in diesel engine oil development.
