ASTM D2510 Standard Test Method for Adhesion of Solid Film Lubricants
1. Scope
1.1 This test method covers the measurement of the adhesion characteristics of dry solid film lubricants.
1.2 The values stated in SI units are to be regarded as standard. The values given in parentheses are provided for information only.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents
2.1 ASTM Standards:
B209M Specification for Aluminum and Aluminum-Alloy Sheet and Plate (Metric)
D1000 Test Methods for Pressure-Sensitive Adhesive-Coated Tapes Used for Electrical and Electronic Applications
D1193 Specification for Reagent Water
D1730 Practices for Preparation of Aluminum and Aluminum-Alloy Surfaces for Painting
D3330/D3330M Test Method for Peel Adhesion of Pressure-Sensitive Tape
F22 Test Method for Hydrophobic Surface Films by the Water-Break Test
2.2 U.S. Military Specification:
MIL-L-46010
3. Terminology
3.1 Definitions:
3.1.1 dry solid film lubricants, n - dry coatings consisting of lubricating powders in a solid matrix bonded to one or both surfaces to be lubricated.
